Hobby & Verzamelartikelen van het thema Bedrading, stekkers, schakelaars

For four solenoid-operated articles (turnouts, signals, relays) without automatic end-position switch-off. Without feedback. Electrically separated for different circuits.

Change over button with feedback.

Change over button with feedback for single-slip turnouts and symmetric three-way turnouts. These two turnout designs require – if properly controlled – connections for the four possible turnout positions. The switch 10526 offers a definite control of the three permissible turnout settings. Additional switches can be connected side-by-side.

A pack of 12 pieces

Single action button for uncoupling tracks.Use this unit wherever power must be supplied for a short time. The individual buttons are electrically insulated and thus they can operate different power circuits.

With built-in reed switch, to be actuated by means of a 42256 magnet.This potential-free switching contact can be installed at any point of a track layout. The size and colour of the sleeper goes with the ROCO LINE-track, thus camouflaging the contact.Can also be used as feedback-momentary contact along with feedback module 10787 or detector 10808.

8-pole connector, e.g. for 10777.

This rectifier is for bridging opposite direction operation for signal blocks, reverse loop safeguarding, etc. It is not suitable for Selectrix operation!

Longer connecting cable for the 6088 and 60880 s 88 decoders. Length 200 cm / 78-3/4".

The relay has 4 single-pole switches. The contacts have a 2 amp capacity. The relay can be activated by a control box, circuit track, contact track, reed switch, or digital decoder.

De stekkers en moffen zijn niet combineerbaar met de vroegere uitvoering (set art.-nr. 7130).

De stekers en moffen zijn niet met de vroegere uitvoering (set art. nr. 7130) combineerbaar.

Netgelijkrichter voor elektrische overbrugging van isolatiepunten (bijv. Voor tegengestelde rijrichting in seindelen of in langzaam bewegende gebieden). Niet geschikt voor digitale banen.

Can be adjusted through a range of about 10 to 35 ohms (Not over 2 watts continuous operation!) By this mean the power to the locomotive is reduced in pre-determined sections of track, as for example down grades, slow zones and station approaches. Not suitable for digital operation.

For operating uncoupler tracks, or momentary power feed to isolated sections.

This set is for older color light signals (item nos. 7239 to 7242) and semaphore signals (item nos. 7039 to 7042), which come equipped for operation with K or M Track. The set includes center rail insulators, wires for connections, and hardware for one signal block.